Laminator Lcd Messages - DataCard RP90 User Manual

Laminator LCD messages

LCD Message
Please Power OFF
Please Reset
Please check inside
Card Jam (in)
Card Jam (middle)
Card Jam (out)
Film search
Film run out
No Cassette
Overcool
HR is too hot!
RP90 Plus E and RL90 User Guide
Possible Cause
To initialize this unit, the
power must be switched
off once.
Displayed when Reset is
necessary after changing
the settings.
The power was switched
off during lamination.
There is a card jam in the
entrance area.
There is a card jam in the
center of the card path.
There is a card jam in the
card discharge area.
The laminator is searching
for laminate material.
The end of the roll mark
has been detected.
The laminator cartridge is
not installed.
The area surrounding the
laminator is too cold.
The heat roller is too hot
for the cleaning operation.
Solution
Turn the laminator's power switch off, and then back
on to initialize the laminator.
Press the RESET/ and then the ENTER key to
initialize the laminator.
Remove the laminator cartridge and check for a card
inside the machine. If there is a card in the machine,
remove it.
Press the RESET/ and then the ENTER key to
initialize the laminator.
Check that the laminator is properly connected to the
"Optional laminator
printer as described in
connection" on page 13
"Card jam" on page 62
See
The laminating temperature is too high or the speed is
too slow. Set the temperature or speed as described in
"Using the Laminator LCD panel" on page 42
"Card jam" on page 62
See
The laminating temperature is too high or the speed is
"Card jam" on page 62
too slow. See
jam.
Check that the laminating film is correctly loaded as
"Load laminate" on page 11
described in
Press the RESET/ and then the ENTER key to
initialize the laminating material.
Replace the laminating material as described in
laminate" on page 11
.
Press the RESET/ and then the ENTER key to
initialize the laminator.
Install the laminator cartridge as described in
laminate" on page 11
.
Press the RESET/ and then the ENTER key to
initialize the laminator.
"Operating environment" on page 72
See
location guidelines.
Turn the power switch off and allow the roller to cool
before attempting to clean it. See
laminator" on page 49
to clean the heat roller.
Laminator error recovery
.
to clear the jam.
.
to clear the jam.
to clear the
.
"Load
"Load
for
"Cleaning the
65