DataCard RP90 User Manual page 38

01039100 Card Jam happens in the printer. Please
open the printer door and remove the
card after turning off the printer power.
01039200 Card Jam happens in the printer. Please
open the printer door and remove the
card after turning off the printer power.
01039300 Card Jam happens in the printer. Please
open the printer door and remove the
card after turning off the printer power.
01039400 Card Jam happens in the printer. Please
open the printer door and remove the
card around the card outlet after turning
off the printer power.
0103A000 Retransfer Film is broken.
0103A100 Mark on Retransfer Film could not be
detected. Please set Retransfer Film
correctly.
0103B000 Ink Ribbon is broken.
0103B100 Ink Ribbon cannot be controlled. Please
set Ink Ribbon correctly.
0103BB00 Card Jam happens in External IC unit.
Please remove the card in External IC
unit.
01044400 Hardware failure happens in the printer
0104D800 unit. Please turn off and on the printer
0104FA00 power to initialize the printer.
32
1 Switch off the printer power.
"Turnover jam" on page 53
2 See
the card.
3 Switch on the printer power.
1 Switch off the printer power.
"Retransfer section jam" on page 54
2 See
remove the card.
3 Check that the card stacker is securely attached
to the card stacker receptacle.
4 Switch on the printer power.
1 Switch off the printer power.
"Retransfer section jam" on page 54
2 See
remove the card.
3 Switch on the printer power.
1 Switch off the printer power.
2 Open the printer door and remove the card near
the card discharge slot.
3 Switch on the printer power.
1 Repair the retransfer film as described in
"Mending broken ink ribbon or retransfer
film" on page 55
.
2 Press RESET and then ENTER to initialize the
printer one ribbon panel.
1 Make sure that the Retransfer Film is loaded
"Load retransfer film" on
correctly (see
page 10
).
2 Close the printer door and press RESET and
then ENTER to initialize the printer.
1 Repair the ink ribbon as described in
broken ink ribbon or retransfer film" on
page 55
.
2 Press RESET and then ENTER to initialize the
printer.
1 Make sure that the Ink Ribbon is loaded
"Load ink ribbon" on page 9
correctly (see
2 Close the printer door and press RESET and
then ENTER to initialize the printer.
1 Switch off the printer power.
2 Remove the jammed card from the IC unit on
the right side of the printer.
3 Switch on the printer power.
1 Turn the printer power switch off and then on.
2 If the error happens again, call for service.
RP90 Plus E and RL90 User Guide
Status Monitor
to remove
to
to
"Mending
).