Using The Printer - DataCard RP90 User Manual

Using the printer

This section describes how to perform basic tasks required to operate the
Datacard® RP90 Plus E printer and the Datacard® RL90 card laminator.
It describes how to:
Load supplies
Power on
Prepare to print cards
Print cards
Begin with the printer set up and the printer driver installed. This printer must be installed
by Datacard authorized and trained personnel. If the printer is not set up, contact your
service provider.
RP90 Plus E and RL90 User Guide
"Load cards" on page 8
•
• "Load ink ribbon" on page 9
"Load retransfer film" on page 10
•
• "Load laminate" on page 11
"Check the PC connection" on page 12
•
"Optional laminator connection" on page 13
•
"Power on the laminator" on page 14
•
• "Power on the printer" on page 15
"Initialize the ink ribbon" on page 16
•
"Set the retransfer film type" on page 16
•
"Initialize the retransfer film" on page 17
•
"Initialize the patch or topcoat material (optional RL90 laminator only)" on
•
page 17
"Print cards using ID software" on page 18
•
"Print from a PC application" on page 19
•
2