DataCard RP90 User Manual page 40

0104F100 Hardware failure of Retransfer Roller
happens. Please turn off and on the
printer power to initialize the printer.
0104F200 Hardware failure of Retransfer Roller
Thermister happens. Please turn off and
on the printer power to initialize the
printer.
0104F300 The temperature of Bend Remedial
Roller is too hot. Please turn off the
printer power till it becomes cool
enough.
0104F400 Hardware failure of Bend Remedial
Roller happens. Please turn off and on
the printer power to initialize the printer.
0104F500 Bend Remedial Roller thermister is out
of order. Please turn off and on the
printer power to initialize the printer.
0104F600 The temperature in the printer is too
cool. Please turn off the printer power till
it becomes warm enough.
0104F800 The temperature of Thermal Head is too
hot. Please turn off the printer power till
it becomes cool enough.
0105FB00 Download data to the printer is invalid.
Please confirm the file is correct.
0142A200 End of Retransfer Film, please replace
the film with a new.
0142B200 End of Ink Ribbon, please replace the
ink with a new.
34
1 Turn the printer power switch off and then on.
2 If the error happens again, call for service.
1 Turn the printer power switch off and then on.
2 If the error happens again, call for service.
1 Switch off the printer power.
2 Wait about 10 minutes for the Bend Remedial
Roller to cool down.
3 Switch on the printer power.
4 If the error happens again, call for service.
1 Turn the printer power switch off and then on.
2 If the error happens again, call for service.
1 Turn the printer power switch off and then on.
2 If the error happens again, call for service.
1 Switch off the printer power.
2 Wait for the surrounding temperature to warm
up.
3 Switch on the printer power.
4 If the error happens again, call for service.
1 Switch off the printer power.
2 Wait about 10 minutes for the Thermal head to
cool down.
3 Switch on the printer power.
4 If the error happens again, call for service.
Check whether the downloaded file is correct.
1 Replace with a new roll of retransfer film. See
"Load retransfer film" on page 10
2 Press RESET and then ENTER to initialize the
printer.
3 Initialize the new roll of film as described in
"Initialize the retransfer film" on page 17
1 Replace with a new roll of ink ribbon. See
ink ribbon" on page 9
2 Press RESET and then ENTER to initialize the
printer.
3 Initialize the new roll of ink ribbon as described
"Initialize the ink ribbon" on page 16
in
RP90 Plus E and RL90 User Guide
Status Monitor
.
.
"Load
.
.