DataCard RP90 User Manual page 46

Menu Display Settings
Subnet Mask
Gateway
Session TimeOut
MAC Address
IPSec Mode
IPSec Type
HR Control ON
OFF
Download
Transport Mode Set transport mode
40
OFF or up to 60 minutes
ON
OFF
Function
The default Subnet Mask of the printer is 255.255.255.0. If
you do not use DHCP, ask your network administrator for the
Subnet mask.
The default Gateway of the printer is 192.168.0.1. If you do
not use DHCP, ask your network administrator for the Subnet
mask.
Set how many minutes to wait without using the printer to stop
the network session between the PC and printer.
The MAC Address is unique to each printer. The MAC
Address is displayed and cannot be changed.
Set the Internet Protocol (IP) Security mode to ON or to OFF.
After setting up security using a PC and USB connection, this
setting cannot be changed.
Set the type of IP Security. Choose from the following:
• Not Setting, no IP Security.
• Preshared, using a preshared key for encryption.
• Certificate, using a public key certificate for encryption.
After setting up security using a PC and USB connection, this
setting cannot be changed.
Set whether to lower the temperature of the retransfer heat
roller after 30 minutes of no printing. The roller returns to
operating temperature when the next card is printed.
Setting HR Control to ON can add to the useful life of the
retransfer heat roller.
To prepare the printer for a firmware download, press the
ENTER key. The firmware must be downloaded from a USB-
connected PC with the driver and Status Monitor installed.
"Others tab" on page 31
See
DO NOT power off the printer while the firmware is being
downloaded.
Set the Transport Mode when moving or shipping the printer.
Press the ENTER key to use the transport mode. "Please,
power off" is displayed on the LCD panel. The transport mode
is cancelled when the printer is powered back on.
"Preparing the printer and laminator for transport"
See
on page 48
for information on preparing the printer for
transporting it.
RP90 Plus E and RL90 User Guide
Using the LCD menus
for the Status Monitor page.