Power On The Printer; Lcd Sequence On Printer Startup - DataCard RP90 User Manual

Power on

Power on the printer

Tips for printer power
To avoid receiving errors
•
on the LCD panel, make
sure that all supplies are
properly loaded and in
position before powering
on the printer.
Wait while the printer
•
initializes.
Follow the guidelines for
•
your organization about
when to power the
printer on and off.

LCD sequence on printer startup

RP90 Plus E and RL90 User Guide
1 Press the "|" symbol on the
power switch.
The printer powers on. The
2
LCD panel shows the firmware
version and the printer begins
initializing. The LCD panel
shows "Initializing" while the
printer checks and positions
the ink ribbon and retransfer
film.
3 When operation checks are
complete, "Preheating" is
displayed on the LCD panel for
approximately four minutes while the retransfer roller and bend remedy
roller warm to their operating temperatures.
The LCD panel shows "Ready" and the Ready Light is steady green.
4
The first time you print cards, initialize the ink ribbon. See
5
the ink ribbon" on page 16
The first time you print cards, set and initialize the retransfer film. See
6
"Set the retransfer film type" on page 16
retransfer film" on page 17
The printer can require up to 4 minutes between power-on and the "Ready"
status.
for the steps to follow.
"Initialize the
and
for the steps to follow.
"Initialize
15