Safety Instructions; Requirements For The Personnel; Intended Use - Endress+Hauser IO-Link Dosimag Operating Instructions Manual

Safety instructions

1) Not applicable for IO-Link measuring instruments
8
2 Safety instructions
2.1

Requirements for the personnel

The personnel for installation, commissioning, diagnostics and maintenance must fulfill
the following requirements:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task.
‣
Are authorized by the plant owner/operator.
‣
Are familiar with federal/national regulations.
‣
Before starting work, read and understand the instructions in the manual and
supplementary documentation as well as the certificates (depending on the
application).
‣
Follow instructions and comply with basic conditions.
The operating personnel must fulfill the following requirements:
‣
Are instructed and authorized according to the requirements of the task by the facility' s
owner-operator.
‣
Follow the instructions in this manual.
2.2

Intended use

Application and media
Depending on the version ordered, the measuring instrument can also be used to measure
1)
potentially explosive , flammable, toxid and oxidizing media.
Measuring instruments for use in hazardous areas, in hygienic applications, or where
there is an increased risk due to pressure, are specially labeled on the nameplate.
To ensure that the measuring instrument is in perfect condition during operation:
‣
Only use the measuring instrument in full compliance with the data on the nameplate
and the general conditions listed in the Operating Instructions and supplementary
documentation.
‣
Using the nameplate, check whether the ordered device is permitted for the intended
use in the hazardous area (e.g. explosion protection, pressure vessel safety).
‣
Use the measuring instrument only for media to which the process-wetted materials
are sufficiently resistant.
‣
Keep within the specified pressure and temperature range.
‣
Keep within the specified ambient temperature range.
‣
Protect the measuring instrument permanently against corrosion from environmental
influences.
Incorrect use
Non-designated use can compromise safety. The manufacturer is not liable for damage
caused by improper or non-designated use.
WARNING
L
Danger of breakage due to corrosive or abrasive fluids and ambient conditions!
‣
Verify the compatibility of the process fluid with the sensor material.
‣
Ensure the resistance of all fluid-wetted materials in the process.
‣
Keep within the specified pressure and temperature range.
Dosimag IO-Link
Endress+Hauser