Beep Tone On/Off - Icom IC-3SAT Instruction Manual

33
12 BEEP AND POWER SAVER
12-1 Beep tone ON/OFF
using S E T MODE
The transceiver emits a beep tone each time a switch is
pushed. To turn OFF the beep tone, use SET mode.
Beep is not emitted. Beep is emitted.
1) Push [A] (CLR) to set VFO mode.
2) While pushing [Е], push [8] (SET) to enter SET mode.
e Refer to p. 8 for SET mode details.
3) Push [*] (v) ог [3] (^) until "BE" appears as shown
above.
4) Rotate the tuning control to select beep "on" or "oFF."
5) Push [A] (CLR) to exit SET mode.
12-2 Power saver function
WITH POWER ON
The power saver function reduces the current drain to
conserve battery power. The function activates 5 sec. after
the squelch closes or no switch is pushed.
A duty cycle of the power saver function (standby : circuit
off) can be selected or turned OFF to suit your desired
operation. A
1) Turn power OFF.
2) While pushing the following switches, turn power ON.
Standby
Circuit off
deactivates approx. 2 sec.