Icom IC-3SAT Instruction Manual page 2

FIRST APPLYING POWER
The IC-3SAT includes NiCd batteries and a rechargeable |
backup battery. If the batteries are low at the time you
purchase the IC-3SAT, the transceiver may not operate
properly.
If the transceiver malfunctions, reset it as follows:
1) Connect the supplied wall charger to the [DC 13.8 V]
jack on the top panel.
2) While pushing [F] and [A] (CLR), rotate [PWR/VOL]
to turn ON power. | |
3) Release the switches. :
e The function display shows 220.00 MHz.
4) Turn OFF power, then wait until the battery pack is
fully charged.
The internal batteries should be fully charged before
using the transceiver.
[PWR/VOL]
Supplied
wall charger
Domestic
AC outlet