Setting Scan Conditions - Icom IC-3SAT Instruction Manual

25
8 SCAN OPERATION
8-3 Setting scan conditions
(1) SETTING THE
PROGRAMMED SCAN EDGES
Scan edge frequency A Scan edge frequency B
1) Push [A] (CLR) to select VFO mode.
2) While pushing [Е], push [8] (SET) to enter SET mode.
e Refer to p. 8 for SET mode details.
3) Push [+] (v) or [#] (A) until "PA" appears as shown
above.
|
4) Set a scan edge frequency using the keyboard or tuning
control.
5) Push [#] (^
. edge frequency.
6) Push [A] (CLR) to exit SET mode.
) ("PB" appears), then set the other scan
The resume condition can be selected as a pause or timer
scan.
|
e While holding the following switches, turn ON power to
change the condition.
- [4] [LIGHT] : Pause scan
(Scan pauses until signal disappears.)
- [B] [LIGHT] : Timer scan (Scan pauses for 10 sec.)
(3 FREQUENCY SKIP FUNCTION
Push and hoid |Ш
&EBDEDBUOBDE
While scan pauses