Icom IC-3SAT Instruction Manual page 34

31
11 CLOCK AND TIMER OPERATION
1-3 Power on timer
The transceiver has a power on timer to fit your schedule
and to save battery power. While the timer is activated,
the transceiver is in the off condition, the function display
shows the clock time and the transmitter and receiver
circuits do not operate. |
1) While pushing [F], push [9] (CLOCK) to enter CLOCK
mode.
2) Set the clock time. See Section 11-2 (p. 30) steps 2~ 5.
3) Push [+] (v) or [Z1 (A) until "TM" appears as shown
above. |
4) While pushing [Е], push [8] (SET). |
e The displayed time blinks. |
5) Rotate the tuning control to set the hours.
6) Push [+] (v) ог [#] (A), then rotate the tuning control
to set the minutes. |
` 7) Push [A] (CLR) to set the time.
8) To start the power on timer:
- While pushing [F], push [A] (CLR).
e The decimal point appears, indicating the power on
timer is activated. |
eDO NOT turn OFF the power with the [PWR/VOL]
control.
To turn ON the transceiver while in the off condition,
turn OFF then ON again using the [PWR/VOL] control.