Switch Logging Commands Overview; Enabling Switch Logging; Setting The Switch Logging Severity Level - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Switch Logging Commands Overview

Switch Logging Commands Overview
This section describes the switch logging CLI commands, for enabling or disabling switch logging,
displaying the current status of the switch logging feature, and displaying stored log information.

Enabling Switch Logging

The swlog command initializes and enables switch logging, while no
To enable switch logging, enter the swlog command:
-> swlog
To disable switch logging, enter the no swlog command:
-> no swlog
No confirmation message will appear on the screen for either command.

Setting the Switch Logging Severity Level

The switch logging feature can log all switch error-type events for a particular switch application. You can
also assign severity levels to the switch applications that will cause some of the events to be filtered out of
your display. The swlog appid level
The syntax for the swlog appid level
a severity level. The severity level controls the kinds of error-type events that will be recorded by the
switch logging function. If an application experiences an event equal to or greater than the severity level
assigned to the application, the event will be recorded and forwarded to the configured output devices. You
can specify the application either by the application ID CLI keyword or by its numeric equivalent.
The application ID information is shown in the following table. The severity level information is shown in
the table beginning on
CLI Keyword
IDLE
DIAG
IPC-DIAG
QDRIVER
QDISPATCHER
IPC-LINK
NI-SUPERVISION
INTERFACE
802.1Q
VLAN
GM
BRIDGE
page 46-6
command is used to assign the severity levels to the applications.
command requires that you identify a switch application and assign it
page 46-8.
Numeric
Equivalent
255
0
1
2
3
4
5
6
7
8
9
10
OmniSwitch AOS Release 6 Network Configuration Guide
swlog disables it.
Application ID
APPID_IDLE
APPID_DIAGNOSTICS
APPID_IPC_DIAGNOSTICS
APPID_QDRIVER
APPID_QDISPATCHER
APPID_IPC_LINK
APPID_NI_SUP_AND_PROBER
APPID_ESM_DRIVER
APPID_802.1Q
APPID_VLAN_MGR
APPID_GROUPMOBILITY (RESERVED)
APPID_SRCLEANING
Using Switch Logging
September 2009