Configuring Remote Port Mirroring - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Port Mirroring

Configuring Remote Port Mirroring

This section describes the steps required to configure Remote Port Mirroring between Source, Intermedi-
ate, and Destination switches.
The following diagram shows an example of a Remote Port Mirroring configuration:
Local MTP
Source switch
Source
Port
1/1
Configuring Source Switch
Follow the steps given below to configure the Source Switch:
-> vlan 1000
-> vlan 1000 stp disable
-> port mirroring 8 source 1/1
-> port mirroring 8 destination 1/2 rpmir-vlan 1000
Configuring Intermediate Switch
Follow the steps given below to configure all the Intermediate Switches:
-> vlan 1000
-> vlan 1000 stp disable
-> vlan 1000 802.1q 2/1
-> vlan 1000 802.1q 2/2
Enter the following QoS commands to override source learning:
-> policy condition c_is1 source vlan 1000
-> policy action a_is1 redirect port 2/2
page 45-22
Intermediate
switch
1/2
2/1
Remote Port Mirroring Example
OmniSwitch AOS Release 6 Network Configuration Guide
Diagnosing Switch Problems
Destination switch
3/1
2/2
Destination Port
RPMir
VLAN
- 1000
3/2
September 2009