Viewing Health Statistics For A Specific Interface; Resetting Health Statistics For The Switch - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Diagnosing Switch Problems

Viewing Health Statistics for a Specific Interface

To view health statistics for slot 4/port 3, enter the show health command, followed by the appropriate
slot and port numbers. A screen similar to the following example will be displayed, as shown below:
-> show health 4/3
* - current value exceeds threshold
Port 04/03
Resources
------------------+----------+--------+--------+---------+--------------------
Receive
Transmit/Receive
In the screen sample shown above, the port 04/03 Resources field displays the port resources that are
being measured (for example, Receive displays statistics for traffic received by the switch, while Trans-
mit/Receive displays statistics for traffic transmitted and received by the switch). The Limit field displays
currently configured resource threshold levels as percentages of available bandwidth. The Curr field
displays current bandwidth usage for the specified resource. 1 Min. Avg. refers to the average resource
bandwidth used over a 1 minute period. 1 Hr. Avg. refers to the average resource bandwidth used over a 1
hour period, and 1 Hr. Max. refers to the maximum resource bandwidth used over a 1 hour period.

Resetting Health Statistics for the Switch

The health statistics reset
command cannot be used to clear statistics only for a specific module or port.
To reset health statistics for the switch, enter the health statistics reset command, as shown below:
-> health statistics reset
OmniSwitch AOS Release 6 Network Configuration Guide
Limit Curr
80 01
80 01
command can be used to clear health statistics for the entire switch. This
1 Min 1 Hr
Avg Avg
01 01
01 01
September 2009
Monitoring Switch Health
1 Hr
Max
01
01
page 45-47