Configuring IP Multicast VLAN
Deleting C-Tag from an IPMVLAN
To delete c-tag from an IPMVLAN, use the no form of the
no vlan ipmvlan followed by the IPMVLAN ID, the keyword ctag, and the customer VLAN ID number,
as shown below:
-> no vlan ipmvlan 1003 ctag 10
Creating and Deleting a Sender Port
The following subsections describe how to create and delete a sender port in an IPMVLAN with the
vlan ipmvlan sender-port
Creating a Sender Port in an IPMVLAN
To create a sender port in an IPMVLAN configured in the Enterprise mode, use the
vlan ipmvlan sender-port
-> vlan ipmvlan 1003 sender-port port 1/50
To create multiple sender ports in an IPMVLAN, specify a range of ports. For example:
-> vlan ipmvlan 1003 sender-port port 1/45-48
In the VLAN Stacking mode, the port that you want to configure as a sender port should be a VLAN
Stacking Network Network Interface (NNI). To create a sender port in an IPMVLAN configured in the
VLAN Stacking mode, use the VLAN Stacking ethernet-service commands and the vlan ipmvlan
sender-port command, as shown below:
-> ethernet-service svlan 1001
-> ethernet-service svlan 1001 nni 1/49
-> ethernet-service ipmvlan 1033
-> vlan ipmvlan 1033 sender-port port 1/49
For more information about how to configure an NNI, see
Deleting a Sender Port from an IPMVLAN
To delete a sender port from an IPMVLAN in the Enterprise or VLAN Stacking mode, use the no form of
the
vlan ipmvlan sender-port
keyword sender-port, and the port number, as shown below:
-> no vlan ipmvlan 1003 sender-port port 1/50
The following command deletes multiple sender ports from an IPMVLAN:
-> no vlan ipmvlan 1003 sender-port port 1/45-48
OmniSwitch AOS Release 6 Network Configuration Guide
command.
command as shown below:
command by entering no vlan ipmvlan followed by the IPMVLAN ID, the
vlan ipmvlan ctag
Chapter 9, "Configuring VLAN Stacking."
September 2009
Configuring IPMVLAN
command by entering
page 43-11