Server Load Balancing Overview; Server Load Balancing Cluster Identification; Server Load Balancing Cluster Modes - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring Server Load Balancing

Server Load Balancing Overview

You can configure up to 16 Server Load Balancing (SLB) clusters on a switch. Each cluster may consist
of 32 servers, which allows for configuration of up to 256 physical servers per switch. The following
sections describe SLB operational theory (see
page 44-7), an SLB example
monitoring (see "Server Health Monitoring" on page
Note. Alcatel-Lucent also offers link aggregation, which combines multiple Ethernet links into one virtual
channel. Please refer to
link aggregation and dynamic link aggregation, and to
tion," for information on static (OmniChannel) link aggregation.

Server Load Balancing Cluster Identification

An SLB cluster consists of a group of physical servers, also known as a server farm. The SLB cluster
appears as one large virtual server, which is identified using one of the following methods:
•
Virtual IP (VIP)—An IP address is assigned to the cluster (virtual server). Client requests destined for
this VIP are routed (Layer-3 mode) to the servers that are members of the VIP cluster. Note that it is
necessary to configure cluster servers with a loopback interface.
•
Condition—A QoS policy condition name is assigned to the cluster (virtual server). Client requests that
meet the criteria of the policy condition are bridged (Layer-2 mode) or routed (Layer-3 mode) to the
servers that are members of the condition cluster. Note that it is not necessary to configure cluster
servers with a loopback interface.
Note. See "Configuring the Server Farm" on page 44-11
"Configuring and Deleting SLB Clusters" on page 44-25
condition clusters.

Server Load Balancing Cluster Modes

The cluster mode refers to whether client requests are bridged (Layer-2 mode) or routed (Layer-3 mode)
by the switch to the appropriate SLB cluster. A VIP cluster only supports Layer-3 mode, so request
packets are always routed to the cluster. A condition cluster supports both Layer-2 and Layer-3 modes.
When the Layer-3 mode is active (VIP or condition clusters), routed packets are modified as follows:
•
The source MAC address is changed to the MAC address for the switch router interface.
•
The destination MAC address is changed to the MAC address of the destined server.
•
The TTL value is decremented.
When the Layer-2 mode is active (condition clusters only), request packets are not modified and are only
switched within the same VLAN domain. The Layer-2 or Layer-3 mode is selected when the condition
cluster is configured on the switch. See
page 44-25 for more information.
OmniSwitch AOS Release 6 Network Configuration Guide
"Server Load Balancing Cluster Identification" on
("Server Load Balancing Example" on page
Chapter 23, "Configuring Dynamic Link
"Configuring an SLB Cluster with a QoS Policy Condition" on
Server Load Balancing Overview
44-8), and server health
44-10).
Aggregation,"for more information on
Chapter 22, "Configuring Static Link Aggrega-
for more information on configuring servers. See
for more information on configuring VIP and
September 2009 page 44-7