Diagnosing Switch Problems
For more information about this command, see
in the OmniSwitch CLI Reference Guide.
Follow the steps below to create a sFlow poller session.
1
To create a sFlow poller session, use the
poller, followed by the instance ID, port list, receiver, and the interval. For example:
-> sflow poller 1 2/6-10 receiver 1 interval 30
Note. Optional. To verify the sFlow poller configuration, enter
poller instance ID. The display is similar to the one shown below:
-> show sflow poller
Instance Interface
-------------------------------------------
1
2/ 6
1
2/ 7
1
2/ 8
1
2/ 9
1
2/10
For more information about this command, see
in the OmniSwitch CLI Reference Guide.
OmniSwitch AOS Release 6 Network Configuration Guide
"sFlow" on page 45-29
sflow poller
Receiver
Interval
1
30
1
30
1
30
1
30
1
30
"sFlow" on page 45-29
September 2009
or the "sFlow Commands" chapter
command by entering sflow
show sflow
poller, followed by the sFlow
or the "sFlow Commands" chapter
sFlow Overview
page 45-9