Global Configuration Mode Commands - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Using ACL Manager
Command
qos {enable | disable}
show logging
show resources
write memory

Global Configuration Mode Commands

The configure terminal command (Privileged Exec Mode) invokes the Global Configuration Mode. The
following commands are available in this mode for configuring ACLs, interfaces, time ranges, and renum-
bering ACL entries:
Command
access-list access-list-number
{permit | deny}
{source source-wildcard | host address | any}
no access-list access-list-number
OmniSwitch AOS Release 6 Network Configuration Guide
Description
Enables or disables QoS policies. By default policies are
enabled. This command is the equivalent of the Alcatel-
Lucent CLI qos enable and qos disable command. Note
that this command applies to both ACLMAN and
Alcatel-Lucent CLI configured policies.
Displays QoS logging information. This command is
equivalent to the Alcatel-Lucent CLI show logging com-
mand.
Displays a summary of QoS resources. The information
displayed is a subset of what is provided with the
Alcatel-Lucent CLI show qos statistics command.
Saves the running ACL configuration to the aclman.cfg
file. Note that if this command is not used, any ACL
configuration since the last write memory is lost when
the switch reboots.
Description
Creates a standard numbered ACL when the ACL num-
ber specified is between 1 and 99 or 1300 and 1999.
Repeat this command for each additional entry you want
to add to the specified access-list-number.
Use the no form of this command to remove the speci-
fied ACL.
Examples:
access-list 10 permit 10.0.0.0 0.255.255.255
access-list 10 deny host 198.172.10.2
access-list 30 permit any
no access-list 10
September 2009
ACLMAN Modes and Commands
page 39-9