Modifying IPMSv6 Parameters
To set the MLD group limit for a VLAN and replace any requests above the limit, use the
vlan max-group
command as shown below:
-> ipv6 multicast vlan 10 max-group 25 action replace
To set the MLD group limit for a port and drop any requests above the limit, use the
max-group
command as shown below:
-> ipv6 multicast port 1/1 max-group 25 action drop
page 42-36
OmniSwitch AOS Release 6 Network Configuration Guide
Configuring IP Multicast Switching
ipv6 multicast
ipv6 multicast port
September 2009