Enabling And Disabling The Mld Spoofing; Enabling The Mld Spoofing; Enabling And Disabling The Mld Zapping - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Modifying IPMSv6 Parameters
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 robustness
To restore the MLD robustness to its default value.

Enabling and Disabling the MLD Spoofing

By default, MLD spoofing (i.e., replacing a client's MAC and IPv6 address with the system's MAC and
IPv6 address, when proxying aggregated MLD group membership information) is disabled on the switch.
The following subsections describe how to enable and disable spoofing by using the
ing command.

Enabling the MLD Spoofing

To enable MLD spoofing on the system if no VLAN is specified, you use the
command as shown below:
-> ipv6 multicast spoofing enable
You can also enable MLD spoofing on the specified VLAN by entering:
-> ipv6 multicast vlan 2 spoofing enable
Disabling the MLD Spoofing
To disable MLD spoofing on the system if no VLAN is specified, you use the
command as shown below:
-> ipv6 multicast spoofing disable
Or, as an alternative, enter:
-> ipv6 multicast spoofing
To restore the MLD spoofing to its default setting (i.e., disabled).
You can also disable MLD spoofing on the specified VLAN by entering:
-> ipv6 multicast vlan 2 spoofing disable
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 spoofing
To restore the MLD spoofing to its default setting (i.e., disabled).
You can remove an MLD spoofing entry on the specified VLAN and return to its default behavior by
entering:
-> no ipv6 multicast vlan 2 spoofing

Enabling and Disabling the MLD Zapping

By default MLD (i.e., processing membership and source filter removals immediately without waiting for
the protocol's specified time period – this mode facilitates IP TV applications looking for quick changes
page 42-34 OmniSwitch AOS Release 6 Network Configuration Guide
Configuring IP Multicast Switching
ipv6 multicast spoof-
ipv6 multicast spoofing
ipv6 multicast spoofing
September 2009