Sample Vlan Configuration - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Sample VLAN Configuration

Sample VLAN Configuration
The following steps provide a quick tutorial that will create VLAN 255. Also included are steps to define a
VLAN description, IP router interface, and static switch port assignments.
Note. Optional. Creating a new VLAN involves specifying a VLAN ID that is not already assigned to an
existing VLAN. To determine if a VLAN already exists in the switch configuration, enter show vlan. If
VLAN 255 does not appear in the show vlan output, then it does not exist on the switch. For example:
-> show vlan
vlan type admin oper
----+-----+-----+----+-----+--------+------+----+-----+-----+--------------
1 std on
2 gvrp on
3 ipmv on
4 vstk on
1
Create VLAN 255 with a description (e.g., Finance IP Network) using the following command:
-> vlan 255 name "Finance IP Network"
2
Define an IP router interface using the following command to assign an IP host address of 21.0.0.10 to
VLAN 255 that will enable routing of VLAN traffic to other subnets:
-> ip interface vlan-255 address 21.0.0.10 vlan 255
3
Assign switch ports 2 through 4 on slot 3 to VLAN 255 using the following command:
-> vlan 255 port default 3/2-4
Note. Optional. To verify the VLAN 255 configuration, use the
-> show vlan 255
Name
Administrative State: enabled,
Operational State
1x1 Spanning Tree State
Flat Spanning Tree State : enabled,
Authentication
IP Router Port
IPX Router Port
Mobile Tag
To verify that ports 3/2-4 were assigned to VLAN 255, use the
-> show vlan 255 port
port type
--------+---------+--------------
3/2 default
3/3 default
3/4 default
page 4-4
stree
1x1 flat
on on on
on off off
on off off
on on on
: Finance IP Network,
: disabled,
: enabled,
: disabled,
: 21.0.0.10 255.0.0.0
: none
: off
status
inactive
inactive
inactive
OmniSwitch AOS Release 6 Network Configuration Guide
mble
auth ip ipx tag
off NA off off
off NA off off
off NA off off
off NA off off
show vlan
forward e2,
show vlan port
Configuring VLANs
name
VLAN 1
GVRPVLAN 2
IPMVVLAN 3
SVLAN 4
command. For example:
command. For example:
September 2009