Quick Steps For Configuring 802.1X - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring 802.1X

Quick Steps for Configuring 802.1X

1
Configure the port as a mobile port and an 802.1X port using the following vlan port commands:
-> vlan port mobile 3/1
-> vlan port 3/1 802.1x enable
The port is set up automatically with 802.1X defaults. See
tion about the defaults. For more information about vlan port commands, see
to VLANs."
2
Configure the RADIUS server to be used for port authentication:
-> aaa radius-server rad1 host 10.10.2.1 timeout 25
See Chapter 35, "Managing Authentication Servers,"
authentication servers for 802.1X authentication.
Note. If 802.1X users authenticate into an authenticated VLAN, the VLAN must be configured with the
vlan authentication
Chapter 4, "Configuring VLANs."
3
Associate the RADIUS server (or servers) with authentication for 802.1X ports:
-> aaa authentication 802.1x rad1
4
(Optional) Associate the server (or servers) to be used for accounting (logging) 802.1X sessions. For
example:
-> aaa accounting 802.1x rad2 ldap3 local
5
(Optional) Configure port-access control parameters for the 802.1X port using the
-> 802.1x 3/1 quiet-period 45 max-req 3
6
(Optional) Configure the number of times supplicant devices are polled for identification using the
802.1x supp-polling retry
-> 802.1x 3/1 supp-polling retry 10
Note. Verify the 802.1X port configuration using the
-> show 802.1x 1/13
802.1x configuration for slot 1 port 13:
direction
operational directions
port-control
quiet-period (seconds)
tx-period (seconds)
supp-timeout (seconds)
server-timeout (seconds)
max-req
re-authperiod (seconds)
reauthentication
Supplicant polling retry count = 2
OmniSwitch AOS Release 6 Network Configuration Guide
command. For information about configuring VLANs with authentication, see
command:
= both,
= both,
= auto,
= 60,
= 30,
= 30,
= 30,
= 2,
= 3600,
= no
Quick Steps for Configuring 802.1X
"802.1X Defaults" on page 37-2
for more information about configuring RADIUS
802.1x command:
September 2009
for informa-
Chapter 6, "Assigning Ports
802.1x command:
page 37-3