Deleting An Slb Cluster; Assigning Servers To And Removing Servers From A Cluster; Assigning A Server To An Slb Cluster; Removing A Server From An Slb Cluster - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring Server Load Balancing

Deleting an SLB Cluster

To delete an SLB cluster, use the no form of the
cluster followed by the name of the cluster.
For example, to delete an SLB called "Web_Server", you would enter:
-> no ip slb cluster Web_Server
Note. When you delete an SLB cluster you also delete the QoS policy, condition, and rule associated with
the cluster.

Assigning Servers to and Removing Servers from a Cluster

The following subsections describe how to assign servers to an SLB cluster and how to remove servers
from an SLB cluster with the
Note. You can also use the ip slb server ip cluster command to administratively disable or enable a
server (see "Taking a Server On/Off Line" on page

Assigning a Server to an SLB Cluster

You assign physical servers to an existing logical SLB cluster with the
by entering ip slb server ip, the IP address of the server in dotted decimal format, cluster, and the name
of the SLB cluster.
For example, to assign a server with an IP address of 10.105.16.118 to an SLB cluster called
"Web_Server", you would enter:
-> ip slb server ip 10.105.16.118 cluster Web_Server
You can assign up to 256 physical servers. For example, to assign three physical servers with IP addresses
of 10.105.16.121, 10.105.16.122, and 10.105.16.123, respectively, to an SLB cluster called
"Web_Server", enter the following CLI commands:
-> ip slb server ip 10.105.16.121 cluster Web_Server
-> ip slb server ip 10.105.16.122 cluster Web_Server
-> ip slb server ip 10.105.16.123 cluster Web_Server

Removing a Server from an SLB Cluster

To remove a physical server from an SLB cluster, use the no form of the ip slb server ip cluster
command by entering no ip slb server ip, the IP address of the server you want to remove in dotted deci-
mal format, cluster, and the name of the SLB cluster.
For example, to remove a server with an IP address of 10.105.16.121 from an SLB cluster called
"Web_Server" you would enter:
-> no ip slb server ip 10.105.16.121 cluster Web_Server
OmniSwitch AOS Release 6 Network Configuration Guide
ip slb reset statistics
ip slb server ip cluster command.
44-30).
September 2009
Configuring Server Load Balancing on a Switch
command by entering no ip slb
ip slb server ip cluster command
page 44-27