Quick Steps For Configuring Switch Logging - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Quick Steps for Configuring Switch Logging

Quick Steps for Configuring Switch Logging
1
Enable switch logging by using the following command:
-> swlog
2
Specify the ID of the application to be logged along with the logging severity level.
-> swlog appid bridge level warning
Here, the application ID specifies bridging and the severity is set to the "warning" level.
3
Specify the output device to which the switch logging information will be sent.
-> swlog output console
In this example, the switch logging information will be sent to the console port.
Note. Optional. To verify the switch logging configuration, enter the
is similar to the one shown below:
Switch Logging is:
Log Device(s)
----------------
flash
console
Only Applications not at the level 'info' (6) are shown
Application ID
----------------------------
BRIDGE(10)
For more information about this command, or the "Switch Logging Commands" chapter in the
OmniSwitch CLI Reference Guide.
page 46-4
- INITIALIZED
- RUNNING
Level
warning (5)
OmniSwitch AOS Release 6 Network Configuration Guide
Using Switch Logging
show swlog command. The display
September 2009