Non-Numeric Error Messages - Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual

Error Message
An underrun error occurred during
communications to the following
device.
An UNKNOWN error occurred
during communications to the
following device.
Device not found.
Invalid Device ID.
The following device is busy.
The following device is closed.
September 2000

Non-Numeric Error Messages

Possible Cause/Subsystem
• The cable between the printer
and the host computer is worn.
• One or more of the connections
between the printer and the host
computer has malfunctioned.
An unknown error occurred in the
application.
The host computer attempted to
contact the printer at the specified
SCSI ID but did not get a response.
The host computer attempted to
contact the printer at the specified
SCSI ID but did not get a response.
The printer at the specified SCSI ID
is busy.
The connection between the printer
and host computer was lost.
Diagnostics and Troubleshooting
Possible Solution
• Check that all of the cables are
properly connected.
• Check the cables and
connections between the printer
and the host computer for wear
and if necessary, replace them.
• Restart the calibration application.
• If the problem continues, make
sure you have the Calibration
Application and ASPI SCSI
device driver installed correctly.
• Make sure that the printer is
turned on and is on-line.
• Make sure the Calibration
Application and ASPI SCSI
device driver are installed
correctly.
Make sure that the printer is turned
on and is on-line
Check that all of the cables are
properly connected.
Check that all of the cables are
properly connected.
5-21