Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual page 39

September 2000
7. Fold the edges of the splice tape over the digital printer paper saver and the
paper.
8. Cut a second piece of splice tape that is slightly smaller than the width of the
paper.
9. Install the second piece of splice tape over the paper and the digital printer
paper saver.
10. Turn the core support assembly to rewind the paper and digital printer paper
saver into the supply cassette.
NOTE: Do not wind the entire digital printer paper saver into the supply
cassette.
Operating Procedures
second piece of
splice tape
3-11