Installing The Takeup Cassette - Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual

September 2000
7. Install the core support assembly into the takeup cassette. See the
instructions on the label on the top of the takeup cassette.
NOTE: Make sure that the core support assembly is installed correctly in the
cutouts of the takeup cassette.
core support assembly
cutout
8. Close the takeup cassette and latch the takeup cassette locks.
NOTE: Be sure the core support assembly rotates freely in the takeup cassette.

Installing the Takeup Cassette

1. Open the takeup door.
If the takeup cassette is in the printer and has paper in it, remove it.
See "Removing the Takeup Cassette" on page 3-20 or "Removing Exposed
Paper from the Takeup Cassette" on page 3-21.
2. If necessary, move the adjustable cassette support arm to accommodate the
size of the cassette you will be using. To move the adjustable arm:
a. Unscrew the clamping knob.
b. Move the arm to the correct position.
c. Reinstall the clamping knob and tighten.
Operating Procedures
takeup
cassette
locks
3-15