Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual page 85

Error Error Code /Status
Code Message
6 The following file already
exists:_filename_.
7 There is not enough space to
create:_filename_.
8 There are too many files to
open _filename_.
9 You do not have permission
to open file _filename_.
10 Error copying print LUT to
DP2 folder (can't open
_filename_.
11 Error creating DP2 LUT
folder
101 No response from
device:_devicename_.
102 Device not
found:_devicename_.
103 The following device is
indicating it is not
ready:_devicename_.
104 The following device is
busy:_devicename_.
105 The following device is not a
TTY port:_devicename_.
106 The following device is
closed:_devicename_.
107 No data on
device:_devicename_.
108 Error:_oserror_occurred
during operation:
_operation_ on device:
_devicename_.
109 Invalid Device ID:
_devicename_.
110 Unable to perform operation:
_operation_
Status Message:_statmsg_
Error Message:_errmsg_.
September 2000
Possible Cause/Subsystem
The system is trying to save to a
file that already exists.
The system is trying to save a file
but there is not enough disk
space.
Too many files open.
The file permission is invalid.
Folder doesn't exist or is read-
only.
A folder of the same name may
exist.
The device is not responding to
the system.
The system was trying to access
a device that it could not find.
The device is not ready.
The device is busy.
The port name in the
configuration file does not refer to
a valid serial port.
The serial port closed during
system reading.
No data is available for the
system to read data on the serial
port.
An operating system error
occurred.
Created a new device with an
incorrect device ID.
An unknown device error
occurred.
Diagnostics and Troubleshooting
Possible Solution
• Delete the existing file.
• Change the filename.
Remove any unnecessary files to
increase free disk space.
Close some files and or
applications.
Rerun the application.
Modify protection on folder.
Change the selected folder name.
Verify that the device is connected
and on-line.
Verify that the device name on one
of the configuration dialog
windows is correct.
Wait several minutes and try the
activity again.
Wait several minutes and try the
activity again.
Change the port name in the
configuration file to a valid serial
port.
• Verify that no other application
is accessing the port.
• Restart the application.
• Verify that the densitometer is
connected correctly.
• Restart the application.
• Rerun the application.
• Reboot the operating system
• If problem continues, call for
service.
• Edit the device ID to reflect the
correct device ID.
Use the information in the status
message and error message to
resolve the device error.
5-15