Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual page 75

Error
Error Message
Code
66 paper jam in shoe
67 rotor not up to speed
68 xltr hard limit detected
69 unexpected xlator front
limit
70 xlator front limit not
detected
71 unexpected xlator back
limit
72 xlator back limit not
detected
74 paper present not
detected
75 unexpected 11 inch
paper
76 11 inch paper not
detected
77 unexpected 20 inch
paper
79 unexpected paper at
shoe entr.
September 2000
Possible Cause
Jam detect sensor detected
jammed paper at the shoe
entrance.
An obstruction in the shoe area
prevented the rotor from achieving
the correct speed in the expected
amount of time.
Either the front or back hard limit
switch was actuated.
The translator front limit switch was
detected unexpectedly.
The translator front limit switch was
not detected after moving translator
to the front of the printer.
The translator back limit switch was
detected unexpectedly.
The translator back limit switch was
not detected after moving translator
to the back of the printer.
Paper was detected at the 11- and
20-inch paper sensors but not at
the 10-inch paper sensors.
Paper was detected at the 11-inch
paper sensor but not at the 10- or
20-inch paper sensors.
Paper was detected at the
10-inch paper, 20-inch paper, shoe
entrance, and the knife sensors but
not at the 11-inch paper sensor.
Paper was detected at the 20-inch
paper sensor but not at the 10- or
11-inch paper sensors.
Paper was detected at the shoe
entrance sensor but not at the
paper width sensor.
Diagnostics and Troubleshooting
Possible Solution
• Remove jammed paper and unload
the takeup cassette.
• If you are using a digital printer
paper saver and the paper jammed
before it was cinched in the takeup
cassette, wipe the paper saver with
a damp, cloth to remove dust and
static electricity.
• Reload the paper.
Wait for at least 1 minute, then clear
the obstruction in the shoe and
confirm that all doors are closed.
• Move the translator off the front or
back hard limit switch. Use the
translator knob.
• Call for service.
Confirm that all doors are closed and
reinitialize the printer.
Confirm that all doors are closed and
reinitialize the printer.
Confirm that all doors are closed and
reinitialize the printer.
Confirm that all doors are closed and
reinitialize the printer.
Check that the paper is loaded and
threaded properly.
Check that the paper is loaded and
threaded properly.
Check that the paper is loaded and
threaded properly.
Check that the paper is loaded and
threaded properly.
Remove any paper from the shoe.
5-5