Selecting A Modem; Resetting The Modem Port; Checking The Modem Presence; Setting The Time And Date - Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual

Operating Procedures

Selecting A Modem

Resetting the Modem Port

1. Select "Setup" from the main menu on the OCP.
2. Select "Ports".
3. Select "Modem (Diag)".
4. Select "Reset Port".
5. Select "Reset Modem Port Now".
NOTE: This causes the modem port to be set to its original factory setting.
6. Select "Exit" to return to the previous menu on the OCP.

Checking the Modem Presence

NOTE: This causes the printer to query the modem port for the presence of a
modem.
1. Select "Setup" from the main menu on the OCP.
2. Select "Ports".
3. Select "Modem (Diag)".
4. Select "Check Presence".
5. Select "Check Modem Presence Now".
6. Select "Exit" to return to the previous menu on the OCP.

Setting the Time and Date

Setting the Current Time

1. Select "Setup" from the main menu on the OCP.
2. Select "Time".
3. Select "Current Time".
4. Use the Up and Down Arrows to select a new time.
5. Press Select to select/set the new value.
6. Select "Exit" to return to the previous menu on the OCP.

Setting the Current Date

1. Select "Setup" from the main menu on the OCP.
2. Select "Time".
3. Select "Current Date".
4. Use the Up and Down Arrows to select a new date.
5. Press Select to select/set the new value.
6. Select "Exit" to return to the previous menu on the OCP.
September 2000 3-33