Calibration Troubleshooting; Calibration Graph; Numbered Error Messages - Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual

Diagnostics and Troubleshooting

Calibration Troubleshooting

Error Error Code /Status
Code Message
1 The following file is
locked:_filename_.
2 The following file is
protected:_filename_.
3 The following file was not
found:_filename_.
4 Error:_oserror_occurred
during operation:_operation_
on file:_filename_.
5 The following file is in an
incorrect format:_filename_.
5-14
This section describes the problems that you may occasionally have when using
the KODAK Device Calibration Software or the Calibration Software for the
KODAK PROFESSIONAL LED II Printer. It also identifies the probable causes for
these problems and provides solutions for correcting these problems.

Calibration Graph

The graph below is an indication that the calibration performed was out of
tolerance.
This may be result from invalid densitometer readings. It is necessary to perform
another calibration cycle if you see a graph that looks like the one above.

Numbered Error Messages

Possible Cause/Subsystem
The system is trying to access a
file that is currently in use.
The system is trying to access a
file that is protected.
The system was trying to access
a file that it could not find.
An operating system error
occurred.
The file does not conform to the
application specification.
Possible Solution
Close any other applications that
may be accessing the file.
Change the protections on the file
to grant access to the user.
Verify that the filename on one of
the configuration dialog windows is
correct.
• Rerun the application.
• Reboot the operating system
Verify the file format.
September 2000