Adjusting The Paper Hole Punchers - Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual

Operating Procedures

Adjusting the Paper Hole Punchers

3-22
6. Remove:
•
screw lock or flange
•
exposed paper from the core support assembly
NOTE: After removing the screw lock, tap the screw lock end of the core to
loosen the paper roll and make it easier to remove from the core support
assembly.
CAUTION: Keep the exposed paper in a darkroom or a dark bag until you
process it.
screw lock
flange
1. Lift the arm for the right paper hole puncher.
2. Move the right paper hole puncher to the correct location. The hole puncher
falls into a detent on the sliding bar when it is in the correct location.
NOTE: The punch positions for A4 and 12 inch paper are very close together
and can be easily mistaken for each other. Make sure you set the paper
hole puncher to the correct position for the paper you are using.
right hole puncher
September 2000