Installation Procedure - Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual

Additional Calibration Information
C-2

Installation Procedure

1. Place the supplied CD-ROM in your CD-ROM drive.
2. When the Browser appears, select LED Printer.
MACINTOSH Version
Under "Download File," select LEDCalAppVn (n is the current version number).
LEDCalAppVn is saved to your desktop.
WINDOWS NT Version
Under "Download File," select KPRO Calibration Utilities.
You can either save the installation file to a hard drive or run it directly from the
Internet.
If you choose to save the installation file to a hard drive, the Save File dialog box
appears. Either accept the path and file name or select another path and file name
and save the file.
MACINTOSH Version and WINDOWS NT Version
NOTE: From this point on, the installation is similar for Macintosh and Windows
NT systems. When the instructions say, for example, click Next or Install,
the first option is for Windows NT systems; the second is for Macintosh
systems.
CAUTION: To avoid possible damage, do not connect or disconnect the cable
between your host computer and the printer when either device
is powered up.
1. Double-click the installation file.
The splash screen for KODAK PROFESSIONAL Universal Calibration Utility
appears and a Setup message appears.
2. After the Welcome screen appears, click Next or Continue.
3. For Macintosh systems only, read the readme information, then click
Continue.
4. Read the license agreement.
• To accept the terms and continue the installation, click Yes or Agree.
Or, to cancel the installation, click No or Disagree.
•
5. For Windows NT systems only, read the readme information, then click Next.
September 2000