Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual page 88

Diagnostics and Troubleshooting
Error Error Code /Status
Code Message
704 CalToleranceFile::
initialize must be called first.
801 Could not find row:_row_.
802 Could not find
column:_column_.
803 Could not find element -
column:_column_.
row:_row_.
804 Row value was not set
before using.
805 Column value was not set
before using.
806 Error deleting row:_row_.
807 Element at row:_row_;
column:_col_
value:_val_ failed audit.
910 Configuration file
field:_filename_is invalid.
Calibration will be cancelled.
911 Error_errcode_occurred.
Processing stopped.
919 Error occurred preparing to
handle exit from Kodak
Calibration. Will not perform
cleanup at exit.
921 Unable to return the printer
to its original state. Fix
printer problem and re-
calibrate.
922 There is already a printer
open. Please close the open
printer first.
5-18
Possible Cause/Subsystem
An internal error occurred with the
software.
An internal error occurred with the
software.
An internal error occurred with the
software.
An internal error occurred with the
software.
An internal error occurred with the
software.
An internal error occurred with the
software.
An internal error occurred with the
software.
An input file had incorrectly
formatted data in it at the location
indicated.
The user manually edited a field
in a configuration file and entered
an incorrect value.
An internal error occurred with the
software.
An internal error occurred with the
software.
The application was trying to
cancel but received an error when
sending the original LUT back to
the printer.
User tried to open a printer when
the printer was already open.
Possible Solution
• Restart the application.
• If problem continues, call for
service.
• Restart the application.
• If problem continues, call for
service.
• Restart the application.
• If problem continues, call for
service.
• Restart the application.
• If problem continues, call for
service.
• Restart the application.
• If problem continues, call for
service.
• Restart the application.
• If problem continues, call for
service.
• Restart the application.
• If problem continues, call for
service.
• Verify that you are using the
correct file.
• Edit the file and correct the
format.
• Manually enter the correct
value.
• Reinstall the application.
• If problem continues, call for
service.
Restart the application.
Restart the application.
Printer is in an unknown state.
Correct any printer problems and
restart the application.
Close the open printer.
September 2000