Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual page 87

Error Error Code /Status
Code Message
202 The following parameter is
invalid:_parametername:
_parametervalue_.
203 The function is not supported
by the class.
204 This function has not been
implemented.
205 Must enter the following
field:_field_.
301 The following key was not
found _key_.
302 The following grouper was
not found:_grouper_.
303 The call depends on a
current grouper, but the
current grouper has not been
set.
501 An error occurred while
applying the data.
601 A bad count was entered.
The expected count
was:_count_.
602 An error occurred during the
calculation process.
701 Patch _patch_, column
_column_, value _value_ is
beyond tolerance
_tolerance_ for aim _aim_.
702 Patch _patch_ has a spread
of _spread_ which is out of
range _range_.
703 CalToleranceFile can only be
initialized once.
September 2000
Possible Cause/Subsystem
An internal error occurred with the
software.
An internal error occurred with the
software.
An internal error occurred with the
software.
The operator left a blank
configuration field.
• An internal error occurred with
the software.
• One of the files was edited
manually and a key was
changed.
• An internal error occurred with
the software.
• One of the files was edited
manually and a grouper was
changed.
An internal error occurred with the
software.
• A file was edited manually and
an incorrect number of rows
was entered.
• An internal software error
occurred.
An internal error occurred with the
software.
A density patch was out of
tolerance.
The spread between colors for a
given density patch is out of
tolerance.
An internal error occurred with the
software.
Diagnostics and Troubleshooting
Possible Solution
• Restart the application.
• If problem continues, call for
service.
• Restart the application.
• If problem continues, call for
service.
• Restart the application.
• If problem continues, call for
service.
Enter information in the blank
configuration field.
• Restart the application.
• Restore the key to its previous
value.
• If problem continues, call for
service.
• Restart the application.
• Restore the grouper to its
previous value.
• If problem continues, call for
service.
• Restart the application.
• If problem continues, call for
service.
• Manually enter the correct
number of rows in the file.
• If problem continues, call for
service.
• Restart the application.
• If problem continues, call for
service.
Perform another calibration cycle.
Perform another calibration cycle.
• Restart the application.
• If problem continues, call for
service.
5-17