Setting The Length Of The Paper Trailer; Setting The Punches - Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual

Operating Procedures

Setting the Length of the Paper Trailer

This value determines the amount of unexposed paper to be added to the trail
edge of the paper wound into the takeup cassette when you send an "Unload
Takeup and Rethread" command.
1. Select "Setup" from the main menu on the OCP.
2. Select "Printer".
3. Select "Trailer".
4. Use the Up and Down Arrows to select a new trailer length (from 0 to 3000
pixels).
5. Press Select to select/set the new value.
6. Select "Exit" to return to the previous menu on the OCP.

Setting the Punches

The printer has two paper punches, the back paper punch (closest to the back of
the printer) and the front paper punch (closest to the front of the printer). The front
paper punch can be adjusted to accommodate the width of the paper.
The printer is capable of three types of paper punches:
Cut Punch—occurs automatically between each print. This punch can be made
by either the back or front paper punch.
Order Punch—controlled by a command that is sent from the host computer. This
punch can be made by either the back or front paper punch.
September 2000 3-27