Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual page 76

Diagnostics and Troubleshooting
Error
Error Message
Code
80 paper at shoe entr not
detected
81 unexpected paper at
knife
82 paper at knife not
detected
85 slack loop err, takeup
paper cinched?
86 slack loop high not
detected
87 timeout waiting to cinch
takeup
89 unexpected deflector
nip up not detected
90 knife front not detected
91 deflector nip up not
detected
92 knife back not detected
93 translator power fault
error
95 unexpected shoe exit
nip detected
5-6
Possible Cause
During paper loading, the lead
edge of the paper was not detected
at the shoe entrance sensor within
the expected amount of time.
• Paper jam occurred as paper
was being reversed from the
knife to the end of roll and paper
was detected at the knife instead
of at the shoe entrance.
• Paper sensor at knife or shoe is
not functioning correctly.
• Paper was not detected at the
knife when it should have been.
• Paper jam occurred.
• Paper sensor at knife or shoe is
not functioning correctly.
The printer was unable to takeup
the slack loop because the paper
was not properly cinched.
Unable to detect slack loop.
The printer door was not closed
within the normal amount of time.
The deflector nip up switch was
detected after moving the deflector
to the down position.
The front switch for the knife was
not detected after moving from front
to back.
The deflector nip up switch was not
detected after moving the deflector
from the down position to the up
position.
Knifeback switch was not detected
after moving knife from front to
back.
A power fault was detected by the
translator puck.
The shoe exit nip made switch was
detected after moving the shoe exit
nip to the nip unmade position.
Possible Solution
Load the paper in less time.
Check that the paper is loaded and
threaded properly. Check for a paper
jam at the knife area.
Check that the paper is loaded and
threaded properly. Check for a paper
jam at the knife area.
Check that the paper is properly
attached to the cardboard core in the
takeup cassette.
Check that the paper is properly
attached to the cardboard core in the
takeup cassette.
Open the takeup door, attach the
paper to the cardboard core in the
takeup cassette and close the takeup
door.
• Check for a paper jam at the sheet
transport area.
• Reinitialize the printer.
Check for a paper jam at the knife
area.
• Check for paper at the sheet
transport area.
• Reinitialize the printer.
• Call for service.
Check for a paper jam at the knife
area.
Close all doors and reinitialize the
printer.
Check for a paper jam in the shoe exit
nip area.
September 2000