Installing The Takeup Cassette; Preparing The Takeup Cassette - Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual

Operating Procedures

Installing the Takeup Cassette

3-14

Preparing the Takeup Cassette

1. Unlatch the takeup cassette locks and open the takeup cassette.
2. Remove the core support assembly.
3. Move the screw adjuster to the correct position for the paper size that you are
loading. Pull the metal spring for the screw adjuster away from the gear and
slide the screw adjuster to the correct position until it locks into place in the
detent.
4. Slide the correct size cardboard core onto the core support assembly. Push
the cardboard core toward the flange until it engages the detent.
5. Install the flanged nut (when using 10-, 11-, 12-inch and A4 paper) or the
screw lock (for 20-inch paper) onto the core support assembly. The core
support assembly uses left hand threads. The threaded parts are color coded
to prevent confusion.
NOTE: Make sure the screw lock or flanged nut is secure.
6. Place three rubber bands over the cardboard core.
IMPORTANT: The rubber bands must have the same thickness and must not
be twisted or wrinkled when installed.
screw
lock
flanged nut
cardboard core
rubber bands
core support
assembly
screw adjuster
September 2000
gear