Resetting The Defaults; Resetting The Parameters; Resetting The Printing Luts - Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual

September 2000
3. Adjust the page starts value to the calculated pixel value. If the white border is
on the:
•
back edge—reduce the page start value by the pixel value
•
front edge—increase the page start value by the pixel value
distance B
cut edge
IMPORTANT: The page start value for each paper width is different.

Resetting the Defaults

Resetting the Parameters

This procedure resets the parameters of the printer to the factory setup (default)
values. To indicate that the values have been reset to the factory setup values, the
word "done" is displayed in parenthesis after "Reset Parameters To Factory" on
the menu.
NOTE: Diagnostic parameters are not reset by this action.
1. Select "Setup" from the main menu on the OCP.
2. Select "Defaults".
3. Select "Reset Parameters to Factory".
4. Select "Exit" to return to the previous menu on the OCP.

Resetting the Printing LUTs

This procedure resets the Printing LUTs stored in nvram to the factory setup
(default) values. To indicate that the values have been reset to the factory setup
values, the word "done" is displayed in parenthesis after "Reset Printing LUTs To
Factory" on the menu.
1. Select "Setup" from the main menu on the OCP.
2. Select "Defaults".
3. Select "Reset Printing LUTs to Factory".
4. Select "Exit" to return to the previous menu on the OCP.
Operating Procedures
distance A
cut edge
3-31