Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual page 86

Diagnostics and Troubleshooting
Error Error Code /Status
Code Message
111 There is insufficient memory
for the requested operation
on device:_devicename_.
112 A communications time-out
occurred during operation on
device:_devicename_.
113 A device driver for the
following device could not be
found:_devicename_.
114 An error occurred during
communications to the
following device:
_devicename_.
115 An operation error occurred
during communications to
the following device:_
devicename_.
116 A software warning has been
issued by the following
device: _devicename_ Error
Message: _errmsg_
117 A software error has been
detected by the following
device: _devicename_ Error
Message: _errmsg_
118 A SCSI ID for the following
device was not found:
_devicename_.
119 The wrong SCSI ID was
specified for the following
device: _devicename_.
120 This device has been setup
for the wrong model of
printer: _devicename_.
121 Unable to read STATUS from
device: _devicename_.
122 The selected LUT contains
data that exceeds the limits
of this printer.
201 An error occurred while
trying to allocate memory.
5-16
Possible Cause/Subsystem
The application does not have
enough memory to complete the
operation.
The connection between the
printer and host computer was
lost.
The application could not find the
necessary device software to
communicate with the printer.
• The cable between the printer
and the host computer is worn.
• One or more of the
connections between the
printer and the host computer
has malfunctioned.
• The cable between the printer
and the host computer is worn.
• One or more of the
connections between the
printer and the host computer
has malfunctioned.
A software error has occurred on
the printer.
An error has occurred on the
printer.
SCSI driver not found.
SCSI ID is incorrect.
Device chosen has not been
found.
Unable to see the printer.
Trying to send a 12-bit LUT to a
10-bit printer.
The system is trying to allocate
memory, however, no memory is
available.
Possible Solution
Close the other applications and
unnecessary windows.
Check that all of the cables are
properly connected.
Make sure that the Calibration
Application and ASPI SCSI device
driver are installed correctly.
• Check that all of the cables are
properly connected.
• Check the cables and
connections between the printer
and the host computer for wear
and if necessary, replace them.
• Check that all of the cables are
properly connected.
• Check the cables and
connections between the printer
and the host computer for wear
and if necessary, replace them.
Resolve printer error condition.
Resolve printer error condition.
Reinstall SCSI driver on host
computer.
Set Target SCSI ID to printer SCSI
ID.
Verify device chosen matches the
printer model.
Check SCSI cable connections.
Select a 10-bit LUT file.
Close any unnecessary
applications.
September 2000