Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual page 21

Go icon
This icon highlights after
you select Go
September 2000
The LED Calibration screen appears.
3. Click Go to start the calibration cycle.
Downloading LUTs and Sending Test Print highlights.
If the configuration file specifies to Ask if processor is in control, the
Process In Control dialog box appears.
The processor is critical to printer calibration. You can calibrate the printer
only if the processor is in control. Densitometers require calibration at regular
intervals. Refer to your densitometer's manual for instructions on how to
calibrate your densitometer.
4. Click Yes.
Using the System
2-3