Operating Procedures
outline of paper
outline of image
Gutter Punches With Cut and Order Punches on Opposite Sides of the Paper
3-28
Gutter Punch—controlled by a command sent from the host computer. See
"Changing the Gutter Width" on page 3-35. This punch is on the same side as the
cut punch and is 0.25 to 1.0 in. inside of the image (depending on the value of the
gutter width).
Cut and Order Punches on Same Side of the Paper
order punch
0.25 in.
white
Cut and Order Punches on Opposite Sides of the Paper
cut punches
gutter width 0.25 in.
cut punches
NOTE: All three types of paper punches are made at the trail edges of the print.
Determining the Location of the Cut and Order Punches
1. Select "Setup" from the main menu on the OCP.
2. Select "Printer".
3. Select "Cut Punches" or "Order Punches".
4. Select "<>Punch Position".
5. Select "front" or "back".
6. Select "<> Punch Enabled".
0.25 in.
cut punches
white
order punch
order punch
front of the printer
order punch
gutter punches
September 2000