Maintaining The Equipment; Maintaining The Printer; Daily Maintenance; Calibrating The Printer - Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual

Maintaining the Printer

September 2000

4 Maintaining the Equipment

This chapter includes information you will need to maintain the KODAK
PROFESSIONAL LED II Printer 20R. The topics are as follows:
Maintaining the Printer .......................................................................................4-1

Daily Maintenance .......................................................................................4-1

Calibrating the Printer ...........................................................................4-1

Removing the Punch Chad ...................................................................4-2
Periodic Maintenance ..................................................................................4-3
Replacing the Air Filter .........................................................................4-3
Daily Maintenance
Calibrating the Printer
Calibrate the printer after every 8 to 10 hours of operation or when you change
paper emulsions.
NOTE: If the environmental temperature changes more than 5
o
(3 Celsius) since the printer was last calibrated, a calibration will be
necessary to maintain the image quality of the prints.
Follow the instructions for calibrating the printer (see "Calibrating the Printer" on
page 2-2).
o
Fahrenheit
4-1