Kodak LED II PRINTER 20R - OPERATOR'S GUIDE Operator's Manual page 77

Error
Error Message
Code
96 shoe exit nip made not
detected
97 unexpected deflector
nip made
98 deflector nip made not
detected
99 timeout clearing data
patch
100 xlator start failed
101 shoe exit nip start failed
102 deflector start failed
109 sheet xport ready
timeout
110 paper detected in
machine
111 xlator home failed
112 invalid paper width
sensor coverage
128 back checksum 0
129 bad checksum 1
130 rotor not stopping
131 xlator at both limits
132 knife at both limits
133 timeout sheet xport
reply
134 duart self test failed
192 – Various software error
219 messages.
September 2000
Possible Cause
The shoe exit nip made switch was
not detected after moving the shoe
exit nip to the nip made position.
The deflector nip made switch was
detected after moving the deflector
to the up position.
The deflector nip made switch was
not detected after moving the
deflector to the up position.
The rotor was not able to be
properly started.
The translator failed to start.
The shoe exit nip failed to start.
The deflector failed to start.
The sheet transport area remains
busy or initializing process is taking
longer than expected.
Paper was detected in the printer
while attempting to load a new roll
of paper.
The translator could not find its
home position after several
attempts.
The paper is not laying flat over the
paper width sensors or the end of
roll has been reached.
ROM test failed at powerup.
RAM test failed at powerup.
Rotor will not turn off.
Both the front and back translator
soft limit switches are actuated.
Both the front and back knife limit
switches are actuated.
The 300 board does not reply to the
200 board within the expected
amount of time.
Duart test failed when the printer
was turned on.
A software problem has occurred.
Diagnostics and Troubleshooting
Possible Solution
Check for a paper jam in the shoe exit
nip area.
Check for a paper jam in the deflector
nip area.
Check for a paper jam in the deflector
nip area.
Call for service.
Call for service.
Call for service.
Call for service.
Call for service.
Remove all paper from the printer and
reload the new roll of paper.
Call for service.
Open the supply door and move the
paper to the correct position.
Reinitialize the printer and call for
service.
Call for service.
Turn off the printer and call for service.
Call for service.
Call for service.
Call for service.
Call for service.
Shut down and restart the printer.
Call for service.
5-7