Table of Contents
Advertisement
Printer Installation
Shipping Brackets Removal
Step 1:
- Rotate printer head box 90 degrees onto one side and remove
printer from large shipping box by pulling out and away from box.
- Before removing the shipping support brackets ensure the printer
is properly placed and balanced
on two or three strips of packing
foam provided.
- Remove the two (2) bolts
securing the metal crossbeam
between the support brackets.
- Remove upper and lower
shipping support brackets (four
bolts total) and install
appropriate stand leg to balance
the printer. Remove wing nut,
retaining bolt, and 4 screws.
Media System Installation
Step 2:
- When installing the right stand leg attach electrical plug connection to printer base;
ensure the plug is aligned straight and square onto the connector to prevent damage to
the electrical pins.
CAUTION:
are extremely fragile; ensure restraining
clips are secure.
- 'Loosely' attach the eight (8) stand leg
screws to the printer base; this will allow
for proper installation of the stand's
crossbar.
Technical Training Guide
KODAK
(1 electrical connection)
plug pins
CAUTION:
Avoid pushing
plug into the
platen assembly.
1200i WIDE-FORMAT PRINTING SYSTEM
(Quick Steps)
9
Advertisement
Table of Contents
