Table of Contents
Advertisement
Powering Up
To power on the unit, connect the provided IEC power cable between the rear panel power connector and an AC power
source. During power-up, the following occurs in the order listed:
1. All backlit buttons (the input buttons and the Logo button) blink amber, red, and green for approximately 15
seconds.
2. The backlit buttons light steadily amber and remain lit for approximately 15 seconds.
3. On IPCP models, the RTS and I/O IPCP LEDs light and remain lit.
4. The backlit buttons blink in sequence once, then turn off.
5. When the unit is ready for operation:
•
If input or output signals are present, the appropriate input and output LEDs light.
•
If a logo has been selected, the Logo button lights amber.
•
The green Mic and Volume LEDs light to the level previously set.
Selecting an Input
Press any of the input buttons on the front panel to select an input. The button lights amber.
You can also select inputs via SIS commands (see
CrossPoint 82 PCS Help File).
Tie the selected input to either of the outputs by pressing the desired output button. The tied buttons light amber,
then turn off.
NOTE: The input buttons cannot select audio and video separately. To select breakaway audio, you must use
PCS or SIS commands.
Using the On-Screen Menu System
The on-screen (OSD) menus are used primarily for the initial setup of the device. The on-screen menu presents
configuration options on a local monitor, and settings can be adjusted with front panel controls.
NOTES:
•
The OSD is available only via the DTP2 scaled output. Displays connected to the (unscaled) HDMI
output cannot show the OSD.
•
The on-screen menu has a default timeout of 60 seconds.
•
The screen examples shown in this section show the OSD screens of a DTP2 CrossPoint 82 IPCP SA.
The OSD for your product may differ slightly.
Input Selection and Ties
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Operation
on page 51) or PCS (see the DTP2
22
Advertisement
Table of Contents
