Front Panel Lockout (Executive Modes); Presets; Input Presets - Extron electronics DTP2 CrossPoint 82 User Manual

Front Panel Lockout (Executive Modes)

The DTP2 CrossPoint 82 switchers have five modes of front panel security lock that limit the operation of the
device from the front panel. When the front panel controls are locked, RS-232, USB, and Ethernet control remain
operational.
NOTE: All lock modes persist after a power cycle.
The front panel lock mode can be selected using SIS commands (see the
page 64) and PCS (see the DTP2 CrossPoint 82 PCS Help file).
The following table shows the functionality that is in place for each mode:
Lock Mode
0
1
2
3
4
•
Mode 0 — Unlocks front panel functions. This is the default setting.
• Mode 1 — Locks all front panel functions. Pressing the Menu button in this mode causes the message
Executive Mode Enabled to appear on the display. This mode can be enabled or disabled only via SIS
commands and PCS.
•
Mode 2 — Locks all front panel functions except input switching, logos, and volume control. Pressing the
Menu button in this mode causes the message Executive Mode Enabled to appear on the display. To enable
lock mode 2, press and hold the Menu and Enter buttons simultaneously for 2 seconds.
•
Mode 3 — Locks all front panel functions except input switching and logos.
• Mode 4 — Locks all front panel functions except volume control.

Presets

Two types of presets can be saved to memory slots and recalled and applied as needed. You can save up to 128
input presets and 16 tie presets.
Input and tie presets can be saved and recalled only through SIS commands (see the
page 60 and Tie Presets

Input Presets

The DTP2 CrossPoint 82 switchers have 128 memory slots in which you can save input presets. These presets
are global to all inputs that contain the settings for use with a matrix switcher. A matrix switcher with multiple types
of video inputs (such as an XTP matrix switcher) can be placed upstream from the DTP2 CrossPoint 82 to expand
the number of video sources.
•
When you recall an input preset, the unit fills the output raster based on the sizing and positioning that it had
at the time the preset was saved. For example, a video source that was configured to be zoomed when it was
previously saved as a preset is still zoomed, even if recalled to a smaller output raster.
•
Input presets can be saved based on one input rate and recalled to a different rate. This enables presets to be
used as aspect ratio or other quick-sizing shortcuts. Because the size and position is saved as a percent of
the raster, the preset can be recalled to any scaled output and the saved size and position are scaled
proportionally on the output.
Input Switching Logos
Unlocked Unlocked
Locked Locked
Unlocked Unlocked
Unlocked Unlocked
Locked Locked
on page 61), and PCS (see the DTP2 CrossPoint 82 PCS Help File).
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Operation
Front Panel Lock commands
Volume Adjustment
Unlocked
Locked
Unlocked
Locked
Unlocked
OSD Menu
Unlocked
Locked
Locked
Locked
Locked
Presets commands
on
on
41