Table of Contents
Advertisement
3. Place the LockIt lacing bracket on the screw and against the HDMI connector, then tighten the screw to secure the
bracket (see
4. Loosely place the included tie wrap around the HDMI connector and the LockIt lacing bracket as shown. If
using a stacked pair of connectors (such as HDMI Inputs 2 and 3), place the tie wrap around both connectors
and the bracket (see
5. While holding the connector securely against the lacing bracket, use pliers or a similar tool to tighten the tie
wrap, then remove any excess length (see
ATTENTION:
•
Do not overtighten the HDMI connection mounting screw. The shield to which it is fastened is very
thin and can easily be stripped.
•
Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel elle est attachée
est très fin et peut facilement être dénudé.
Twisted Pair Recommendations for DTP, XTP, and HDBT Communication
Use the following pin configurations for shielded twisted pair cables used for DTP, XTP, or HDBaseT
communication.
Pin
TIA/EIA T568B
Wire Color
1
White-orange
2
Orange
3
White-green
4
Blue
5
White-blue
6
Green
7
White-brown
8
Brown
Figure 12.
Twisted Pair Cable Configuration
Supported cables
The switchers are compatible with shielded twisted pair (F/UTP, SF/UTP, and S/FTP) cable.
ATTENTION:
•
Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201 cable to link the device
with DTP transmitters or receivers.
•
N'utilisez pas le câble AV Skew-Free UTP version améliorée UTP23SF d'Extron ou le câble STP201
pour relier le appareil avec les émetteurs ou les récepteurs DTP.
figure
11,
on the previous page).
3
figure 10
on the previous page).
Pins:
12345678
Insert Twisted
Pair Wires
RJ-45
Connector
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Installation
figure
11,
).
4
18
Advertisement
Table of Contents
