Hdmi Connections - Extron electronics DTP2 CrossPoint 82 User Manual

HDMI Connections

Use Extron LockIt cable lacing brackets to secure HDMI cables to the unit.
Mounting orientations
The HDMI device must have an HDMI connection mounting screw for this bracket to be used. Depending on the
location of the mounting screw in relation to the HDMI connector, the LockIt bracket can be mounted to the screw
at either side of the connector (side mounted) or above it (top mounted). Two HDMI cables can also be attached
to one side mounted bracket (stack mounted).
U T
T P
O U
M I
H D
3
Top Mounted
Figure 10. LockIt Bracket Mounting Orientations
The DTP2 CrossPoint 82 HDMI connectors require the LockIt brackets to be mounted as follows:
• HDMI inputs 2, 4, and 6 — Side mounted. Can be stacked with the connectors below them.
• HDMI inputs 3 and 5, HDMI Loop Out — Stack mounted. Because these connectors have no mounting
screws of their own, each must be stack-mounted with the connector above it:
HDMI Input 2 with HDMI Input 3
•
HDMI Input 4 with HDMI Input 5
•
HDMI Input 6 with Loop Out
•
• HDMI Output 1 — Top mounting (shown in figure 11)
Bracket mounting procedure
To securely fasten an HDMI cable to a device:
1
3
4
3
Figure 11. Top Mounting a LockIt Cable Lacing Bracket
1. Plug the HDMI cable into the panel connection (see figure 11,
2. Loosen the HDMI connection mounting screw from the panel enough to allow the LockIt lacing bracket to be
placed over it (
2
U T
T P
O U
M I
H D
Side Mounted
2
). The screw does not have to be removed.
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Installation
U T
T P
O U
M I
H D
Stacked
2 4
3 5
).
1
6
LOOP OUT
INPUTS
17