Table of Contents
Advertisement
4. Click Update to begin (
the Update Firmware panel.)
During the updating process, a window appears in the middle of the screen, showing the progress of the
update: Uploading, Initializing, Writing to Flash, and Rebooting (see figure 56).
Figure 56. Firmware Update Progress Window
When the update is completed, the progress window closes and the message Firmware Upload Complete
appears near the top of the screen. The new firmware filename appears beside Version in the Firmware
panel of the web page.
Network Settings Panel
In the Network Settings panel (see
gateway address for your DTP2 CrossPoint 82, and turn DHCP on and off. You can also view the MAC address
of the unit. To set the IP addresses:
1. Click Edit in the lower-left corner of the Network Settings panel. The EDIT Network Settings screen
opens.
Figure 57. Edit Network Settings Screen
2. Edit the network settings as desired:
•
DHCP — Click the DHCP button (see figure 57,
(On), the unit configures its IP address and other network settings from the DHCP server. The default is
Off.
•
IP Address, (
click in the desired field and enter the address.
). (If you want to cancel the update, click the X button in the upper-right corner of
2
figure
48,
), Subnet mask (
), and Gateway address (
2
3
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Internal Web Pages
, on page 91), you can set the IP address, subnet mask, and
7
) to toggle DHCP on and off. When DHCP is enabled
1
4
) — To set any of these addresses,
97
Advertisement
Table of Contents
